Jide Oyelayo
CV

Lab / Zybo FPGA filter playground

Zybo FPGA filter playground

What this demonstrates: Try ten Verilog coursework filters on looping video samples, from colour and brightness effects to blur, sharpening and edge detection.

Input

What each filter does

Sepia
Mixes the red, green and blue channels to give the image a warm brown tint.
RGB inversion
Subtracts each colour channel from 255, turning each colour into its complement.
Inverted greyscale
Converts the image to greyscale, then swaps light and dark.
Half brightness
Halves each colour channel to darken the image.
Double brightness
Doubles each colour channel and caps it at 255 so highlights saturate.
3×3 Gaussian blur
Softens fine detail by averaging a greyscale pixel with its neighbours, giving more weight to nearby pixels.
3×3 box blur
Smooths the image by giving all nine greyscale pixels in the window equal weight.
Adjustable sharpening
Adds a scaled difference between each greyscale pixel and its four direct neighbours to bring out detail.
Laplacian edge detection
Compares each greyscale pixel with its eight neighbours and displays the strength of the response in either direction.
Seven-band rainbow tint
Uses each pixel’s greyscale brightness to tint it with one of seven colours, chosen by its horizontal position.

About the video samples

The moving test pattern highlights changes in colour and fine detail. The other two clips animate photographs with camera movement. Waterfall and rocks is based on a photograph by Paul Jarvis. Glass towers is based on a photograph by Anthony DELANOIX.

From Verilog to the browser

I wrote these filters in Verilog for a Zybo Z7-20 coursework project. This playground applies the intended filter math in the browser. It uses a true 3×3 neighbourhood for spatial filters, repeats the nearest pixel at the image border, and clamps output to 8 bits. The coursework Verilog uses different buffering and arithmetic, and its committed Vivado reports show timing violations.